Import Mbed OS hard-float snapshot

targets/TARGET_Samsung/TARGET_SIDK_S5JS100/modem/modem_prj.h

@@ -0,0 +1,63 @@
+/****************************************************************************
+ *
+ * Copyright 2020 Samsung Electronics All Rights Reserved.
+ * SPDX-License-Identifier: Apache-2.0
+ *
+ * Licensed under the Apache License, Version 2.0 (the "License");
+ * you may not use this file except in compliance with the License.
+ * You may obtain a copy of the License at
+ *
+ * http://www.apache.org/licenses/LICENSE-2.0
+ *
+ * Unless required by applicable law or agreed to in writing,
+ * software distributed under the License is distributed on an
+ * "AS IS" BASIS, WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND,
+ * either express or implied. See the License for the specific
+ * language governing permissions and limitations under the License.
+ *
+ ****************************************************************************/
+
+#ifndef __MODEM_PRJ_H__
+#define __MODEM_PRJ_H__
+
+/* interrupt masks.*/
+#define INT_MASK_VALID      0x0080
+#define INT_MASK_CMD        0x0040
+#define INT_VALID(x)        ((x) & INT_MASK_VALID)
+#define INT_CMD_VALID(x)    ((x) & INT_MASK_CMD)
+#define INT_NON_CMD(x)      (INT_MASK_VALID | (x))
+#define INT_CMD(x)          (INT_MASK_VALID | INT_MASK_CMD | (x))
+#define INT_CMD_MASK(x)                 ((x) & 0x1F)
+
+typedef enum {
+    INT_CMD_INIT_START              = 0x1,
+    INT_CMD_COLD_BOOT               = 0x2,
+    INT_CMD_WARM_BOOT               = 0x3,
+    INT_CMD_INIT_END                = 0x2,
+    INT_CMD_REQ_ACTIVE              = 0x3,
+    INT_CMD_RES_ACTIVE              = 0x4,
+    INT_CMD_REQ_TIME_SYNC           = 0x5,
+    INT_CMD_REQ_OFF                 = 0x6,
+    INT_CMD_CRASH_RESET             = 0x7,
+    INT_CMD_PHONE_START             = 0x8,
+    INT_CMD_ERR_DISPLAY             = 0x9,
+    INT_CMD_CRASH_EXIT              = 0x9,
+    INT_CMD_CP_DEEP_SLEEP           = 0xA,
+    INT_CMD_NV_REBUILDING           = 0xB,
+    INT_CMD_EMER_DOWN               = 0xC,
+    INT_CMD_PIF_INIT_DONE           = 0xD,
+    INT_CMD_SILENT_NV_REBUILDING    = 0xE,
+    INT_CMD_NORMAL_POWER_OFF        = 0xF,
+    INT_CMD_MODEM_RELEASE           = 0x10,
+    INT_CMD_MAX                     = 0x11,
+} MODEM_INT_CMD;
+
+enum direction {
+    TX = 0,
+    RX,
+    MAX_DIR
+};
+
+
+#endif
+